Q&A
Q&A
A:

1.Try a new SD card

2.Reinsert the panel cable

3.Reinsert the motherboard cable

4.SD Card slot replacement

A:

1.Confirm whether the filament is stuck

2.Nozzle heating, one hand press extruder, other hand push the filament

A:

1.Check if the filament is damping

2.Teflon tube clogs & jams

3.Parameter setting error

4.Travel speed get accelerate

5.Nozzle temperature is too high

A:

1.Check if the extruder fan is spinning

2.Confirm whether the filament is stuck

3.Check whether the extruder gear is stuck or not

4.Heat the nozzle, try to push the filament

5.reference video:

https://www.youtube.com/watch?v=HoEOW0d1dJw(about 42s)

A:

1.Make sure the filament is fixed to prevent the filament  from causing knots

2.Reference video:

https://www.youtube.com/watch?v=InbBL0UQ1hY

A:

1.Check if the filament is stuck

2.Replace the equipped nozzle

3.Check whether the extruder gear is stuck or not

4.PLA can not use high temperature resistant nozzle

5.Check slice parametrs

A:

1.Check if the filament is retreat

2.The screws of the heat sink is not loose enough, and they are stuck in the nozzle throat groove

3.Nozzle throat is damaged and cannot be removed

A:

1.Confirm the first layer setting, and then height calibration

2.Wipe the glass plate clean, perform auto-leveling, and then height calibration

3.PLA : Use white glue and 60 degrees heated bed on glass plate

4.ABS: Use 3M blue type and 90 degrees heated bed on glass plate

A:

1.當你按下螢幕介面裡面的加熱小圖卻沒有持續升溫

2.電表量測短路

A:

1.Check whether the support parameter XYZ Gap is set too small

 
 
A:

Address:

No.223, Shuimei Rd., Waipu Dist., Taichung City 438, Taiwan(R.O.C)

TEL:04-26876568 / 04-26880209(3D Printing Service department)

FAX:04-26876567

A:

Provide three ways

1.Use paper (about 0.1 mm thickness), the paper can be pulled after the nozzle touches the paper and it can be set to zero

2.Parameter setting, modify value(If the nozzle drop is too low, change the number smaller)

3.Adjust the height of the Z axis to the setting during the printing process (Adjust once 0.025mm)

※Automatically save records

※When to use layer height setting: first printing、change nozzle、replacement the glass plate

A: